Convert From Cylinder Ice To Crushed Ice - Vogt HE S Series Installation & Start-Up Instructions

Installation & Start-up – HES Series
Remove jumper from #5 and #6 on terminal block and put on #5 and #4. This will reverse the rotation
of the cutter motor.
Adjust Freezer Pressure switch (FPS2) – See table below for recommended pressure settings
Turn top screw to adjust the pressure setting
Clockwise = increase pressure setting
Counterclockwise = decrease pressure setting
The pressure switch should be adjusted until the desired ice thickness is obtained--See table below for
recommended ice weights
Note: Single to Dual Ice Conversion kit available – part #: 12AHES01

Convert from Cylinder Ice to Crushed Ice

Cylinder Ice (psig)
Machine R22
HES-20S 43 - 45
HES-20M 38 - 40
HES-30S 38 - 40
HES-30M 35 - 37
HES-40S 31 - 33
HES-40M 25 - 27
Recommended Freezer Pressure Settings
(also referred to as the Range)
The bottom screw is used to set the
Differential – DO NOT ADJUST
Freezer Pressure Switch (FPS2)
Cylinder Ice (lbs.)
Machine
HES-20S
HES-20M
HES-30S
HES-30M
HES-40S
HES-40M
Recommended Ice Weights per cycle
Crushed Ice (psig)
404A R22
56 – 58 46 - 48
49 – 52 41 – 43
49 – 52 41 – 43
46 – 48 39 – 41
42 – 44 36 – 38
34 – 37 31 – 33
TABLE 10
Crushed Ice (lbs.)
41 – 43 30 – 32
40 – 42 29 – 31
41 – 43 30 – 32
40 – 42 29 – 31
41 – 43 30 – 32
40 – 42 29 – 31
TABLE 11
42
404A
59 – 61
53 – 56
53 – 56
50 – 53
47 – 49
42 - 44