Notes On Anti-Theft Device; Anti-Theft Device - Fronius 1.5-1 Installation Instructions Manual

Notes on Anti-theft device

Anti-Theft An optional anti-theft device is included in the scope of delivery.
Device If required, the anti-theft device is installed before the inverter is screwed to the
wall bracket.
To ensure that the fixing screws cannot fall out in the inverter's data communica-
tions area, these are fitted with a screw release.
To remove the fixing screw from the inverter
-
-
Installing the Anti-Theft Device
IMPORTANT! Please refer to the instructions for attaching the inverter to the
wall bracket.
40
Push the fixing screw upwards from the other side e.g. using needle-nose pli-
ers
Undo the fixing screw
TX25
1
TX25
Swing the inverter out
1
Push the fixing screw upwards
2
from the other side e.g. using
needle-nose pliers
Undo the fixing screw
3
Insert the fixing screw into the
4

anti-theft device

Insert the anti-theft device plus
5
fixing screw into the inverter
Swing the inverter in
6
Tighten both fixing screws to the
7
specified torque
22.1 lbf.in
2.5 Nm