Programmable-Unit - A&D GX-M Series Instruction Manual

19.Programmable-Unit

This is a programmable unit conversion function. It multiplies the weighing data in grams by an
arbitrary coefficient set in the function table and displays the result.
The coefficient must be within the range between the minimum and maximum shown below. If the
coefficient set is beyond the range, an error is displayed and the balance returns to the coefficient
setting mode, prompting to enter an appropriate value. A coefficient of 1 was set at the factory.
GX/GF-8202M/8202MD/10202M
GX/GF-12001M/22001M/32001M/32001MD
Operation
1. Press and hold the
2. Press the SAMPLE key several times to display
3. Press the PRINT key. The balance enters the mode to confirm or set the coefficient.
Confirming the coefficient
4. The current coefficient is displayed with the first digit blinking.
□ When it is not to be changed, press the
□ When it is to be changed, press the
proceed to step 5.
Setting the coefficient
5. Set the coefficient using the following keys.
SAMPLE key ꞏꞏꞏꞏꞏꞏꞏ To select a digit to change the
RE-ZERO key ꞏꞏꞏꞏꞏꞏ To change the value.
MODE key ꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏ To change the decimal point
PRINT key ꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏ To store the new setting, display end and go
CAL key ꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏ To cancel the new setting and go to step 6.
Quitting the operation
6. The balance displays
return to the weighing mode.
Using the function
Press the MODE key to select the programmable-unit (no display on the unit section). Perform
weighing as described in "6-1 Basic Operation (Gram Mode)". After weighing, the balance displays
the result (weighing data in grams x coefficient).
Model
SAMPLE key until
value. The selected digit blinks.
position.
Each time the switch is pressed,
the decimal point position
changes as follows:
to step 6.
Unit . Press the
Minimum
coefficient
0. 000001
ba5fnc of the function table is displayed.
.
CAL key and proceed to step 6.
RE-ZERO key and
CAL key to exit the programmable-unit function and
118
Maximum
coefficient
100
10