Programmable-Unit - A&D GF-1200 Instruction Manual

14. PROGRAMMABLE-UNIT

This is a programmable unit conversion function. It multiplies the weighing data in grams by an
arbitrary coefficient set in the function table and displays the result.
The coefficient must be within the range between the minimum and maximum shown below. If the
coefficient set is beyond the range, an error is displayed and the balance returns to the coefficient
setting mode, prompting to enter an appropriate value. A coefficient of 1 was set at the factory.
Model
GF-200/300/400/600/800/1000
GF-1200/2000/3000/4000/6100
GF-6000/8000
Operation
1 Press and hold the SAMPLE key until ba5fnc of the function table is displayed.
2 Press the SAMPLE key several times to display
3 Press the PRINT key. The balance enters the mode to confirm or set the coefficient.
Confirming the coefficient
4 The current coefficient is displayed with the first digit blinking.
When it is not to be changed, press the CAL key and proceed to step 6.
When it is to be changed, press the RE-ZERO key
and proceed to step 5.
Setting the coefficient
5 Set the coefficient using the following keys.
SAMPLE key
RE-ZERO key
MODE key
PRINT key
CAL key
Quitting the operation
6 The balance displays
return to the weighing mode.
Using the function
Press the MODE key to select the programmable-unit (no display on the unit section). Perform
weighing as described in "6-1 Basic Operation (Gram Mode)". After weighing, the balance
displays the result (weighing data in grams x coefficient).
Minimum coefficient
0.000001
To select a digit to change the
value. The selected digit blinks.
To change the value.
To change the decimal point
position.
Each time the switch is pressed,
the decimal point
changes as follows:
To store the new
display end and go to step 6.
To cancel the new setting and
go to step 6.
Unit . Press the CAL key to exit the programmable-unit function and
53
Maximum coefficient
1000
100
10
mltCadj
.
position
setting,