Table of Contents
Advertisement
INSTALLING THE SOFTWARE
Check the contents of the package on the screen, and then click
9
the "Start" button.
The software packages to be installed will be displayed on the screen. If inappropriate
packages are displayed, click the "Back" button to select appropriate packages again.
Once the installation starts, each installer of the selected software packages will
run automatically. If you have selected all the software packages, you can install
the software packages by following the steps shown below.
When any of "Add New Hardware Wizard", "Update Device Driver Wizard", "New
Hardware Found", or "Found New Hardware Wizard" messages appear during the
software installation, be sure to click the "Cancel" button.
Device Driver
1) After confirming the message in the "Welcome" window, click the "Next"
2) In Windows XP/2000, the following message will appear. Read the
34
Downloaded from:
http://www.usersmanualguide.com/
If you connected the unit using a parallel interface cable in Windows Me/98, the
following window will appear. Click the "OK" button.
If you connected the unit using a USB cable in Windows Me/98 and the following
window appears, click the "Cancel" button. Continue following the on-screen
instructions until the entire installation is completed. Not all of the software will
have been installed successfully, so correctly connect the USB cable and then
repeat the installation procedure from the beginning.
button.
The setup program will start to copy the files.
message carefully and then click the "OK" button.
These messages do not appear in Windows Me/98/95/NT 4.0. Proceed to the
next step.
Windows XP
Windows 2000
Advertisement
Table of Contents
