Section 10-System Reconfiguration; Data Cards; Software Part Numbers - Garmin CIRRUS PERSPECTIVE SR20 Line Maintenance Manual

__________________________________________________________________
The information in this section describes how to completely reconfigure the system. The initial
system software upload and configuration took place at the time of installation as described in
the installation manual. Section 7 of this manual explained how to upload, configure, and test
software for a replacement LRU.
Perform system reconfiguration only after talking with GARMIN Field Service
to find out if there is an alternate solution to a problem. System
reconfiguration is a last resort when all other troubleshooting efforts have
been exhausted.
10.1 DATA CARDS
Garmin recommends using SanDisk cards to load system software and configuration files. If
software loading problems occur when using another brand of card, replace the card with a
SanDisk card and attempt the upload procedure again.
10.2 SOFTWARE PART NUMBERS
Software part numbers and software versions are not listed in this manual. For actual software
versions and part numbers refer to Cirrus maintenance documentation.
Screen shots and examples in this section are used to illustrate the software and
configuration loading process. They are representations only. Always refer to
the correct GA drawing for the correct software file names, versions, and part
numbers.
Cirrus Perspective™ Line Maintenance Manual
190-00920-00
SECTION 10
SYSTEM RECONFIGURATION
NOTES
NOTE
Page 10-1
Rev. E