Johnson Controls LC-200 Installation Instructions

2012/19/EU
1. INTRODUCTION
LC-200/BLC-200 detectors are the best choice for residential and commercial security installations: BLC-200 is not UL/ULC listed.
They only use digital PIRs which bypass the conversion that usually must be done with traditional detectors where an analog PIR is amplified and converted
to digital. The FULLY digital technology helps the detector more accurately detect intrusions and not be affected by alterations in white light, ultraviolet light,
temperature, air movement caused by heating/cooling systems, and it is fully immune to radiated and conducted electromagnetic interference. LC-200/BLC-200
detectors are equipped with lenses designed by Johnson Controls and are manufactured by Fresnel Technologies, Inc.
LODIFF optic creation technology combined with POLY IR
®
LC-200/BLC-200 detectors are pet immune (feature not evaluated by UL/ULC) and have a 15-meter range at a 100-degree angle.
White Light Protection
The detector digitally filters white light components.
High RFI Protection
The detector has very high RFI immunity due to the
complete lack of traditional amplifiers.
Ultraviolet Stabilization
POLY IR
The lens is printed with POLY IR
This materials offers a better combination of
transmittance, environmental stability and color
than any other polymer on the market. Materials
are available for the 8-14 micron infrared region.
LODIFF
Fresnel Technologies, Inc.
2. INSTALLATION
- Using a thin screwdriver, loosen the bottom screw and open the cover (see Fig 1)
- Remove the board from the base by levering the ABS cover (see Fig 2)
- Drill the stopper on the base of the cover at the desired fastening location (or use the optional swivel that is not IMQ certified)
- Open the knockout for the removal protection and fix the anchor to the wall (see Fig 2)
- Recommended height is 2 m
- Slide the cable in through the back slot and out the top hole
- Wire the terminals following the connections shown in"Connection and Setup"
- Fig 2 -
NOTE: Do not partially or completely cover the detector's field of vision
NOTE: the pet function is not IMQ certified
ISTISJCEBLC200 0.0
LC-200/BLC-200
materials make it a product of the highest quality and efficiency.
®
4 Lens Material
®
® material.
and POLY IR are registered trademarks of
® ®
LC-200/BLC-200
IR DETECTOR
Anchor
1
Fully Digital PIR
The detector has no analog components, and
the fully digital PIR interfaces directly with the
microprocessor.
Pet Immunity
Thanks to a new lens design and the digital analysis
system, all of our detectors are immune to pets
weighing up to 15 kg.
LODIFF Fresnel Lens Technology
®
This lens series is made by tiling LODIFF
These lenses offer significantly improved performance
over the typical constant-bandwidth Fresnel lens.
LODIFF and POLY IR are registered trademarks of
® ®
Fresnel Technologies, Inc.
- Fig 1 -
Jumpers
Installation Instructions
lens pieces.
®
DIP Switch