Commissioning - MDT Switch 55 Technical Manual

Technical Manual
Motion Detector/Automatic Switch 55/63
Brightness
The correction of the measured brightness value and the sending conditions for the light value can
be set here.
Buttons (only SCN-BWM55/63T.x2)
Two buttons are available on the unit. Using these buttons, functions such as switching, dimming,
blinds or sending a value can be carried out - both individually and in groups - as well as internal
functions that relate to switching to manual mode or lock/forced operation.
Temperature (only SCN- BWM55/63T.x2)
By activating the sensor, the measured temperature can be sent to the bus. In addition, the
transmission behaviour of the measured value as well as a correction value can be configured.
Long Frame Support
Device supports the sending of longer telegrams and thus the storage of more user data per telegram.
This significantly shortens the programming time (from ETS5).
Requirements: Use of a programming interface which supports the transmission of long frames, e.g.,
MDT SCN-USBR.02 or SCN-IP000.03 / SCN-IP100.03.
Updateable via DCA (from Hardware Version R2.0)
If necessary, the actuators can be updated with the help of the MDT Update Tool.

2.5 Commissioning

After wiring, the allocation of the physical address and the parameterization of every channel follows:
(1) Connect the interface with the bus, e.g., MDT USB interface.
(2) Switch on the bus voltage.
(3) Press the programming button on the side of the unit (red programming LED lights up).
(4) Loading of the physical address out of the ETS-Software by using the interface (red LED goes
out, as well this process was completed successful).
(5) Loading of the application, with requested configuration.
(6) When the unit is ready for operation, the desired function can be tested (is also possible with
the help of the ETS software).
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
7
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
Series .02