Table of Contents
Advertisement
Technical Manual
Motion Detector/Automatic Switch 55/63
4.7 Scenes
The following picture shows the setting options for scenes:
Figure 33: Settings – Scenes
The following table shows the setting options for scenes:
ETS-Text
Scene A – H number
Scene A – H
Light channel 1 / 2
Table 44: Settings – Scenes
With the scene function, actions for light channels 1 and 2 (not HVAC and Alarm) can be triggered by
sending the corresponding scene numbers.
Important: Actions can only be configured for light channels that have also been activated via
"Channel selection"! If, for example, only light channel 1 is active, only "Scene X light channel 1" will
be displayed for the corresponding scene X.
The following table shows the corresponding communication object:
Number
Name/Object Function
94
Scene – Input
Table 45: Communication object – Scene
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
51
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
Dynamic range
[Default value]
1 – 64
[not active]
•
not active
•
lock active, ON
•
lock active, OFF
•
lock active
•
disable lock (last state)
•
lock disable, OFF
•
Set external push-button short to
value 1
•
Set external push-button short to
value 0
•
Set external push-button long
(manual mode) to value 1
•
Set external push-button long
(manual mode) to value 0
•
Set object Day/Night to Day (for all
channels)
•
Set object Day/Night to Night (for
all channels)
Length
1 Byte
Series .02
Comment
Setting of the scene number
Settings of the action to be
performed for the light
channels 1/2 by calling up a
scene.
Important:
Actions can only be set for
active light channels!
Usage
Call-up of a scene
Advertisement
Table of Contents
