Table of Contents
Advertisement
Technical Manual
Motion Detector/Automatic Switch 55/63
4.5.2.4 Basic function – Blinds/Shutter
Single-button function
The blinds/shutter function is used to control shutter actuators, which can be used for the
adjustment and control of blinds/shutters.
The following figure shows the available settings:
Figure 29: Settings – Single-button function: Blinds/Shutter
The following table shows the available settings:
ETS-Text
Operation function
Table 36: Settings – Single-button function: Blinds/Shutter
3 communication objects appear for the blind function. On the one hand, the movement object
"Blinds up/down" and on the other hand the function for the stop/step object "Slats
adjustment/stop". The movement object is used to raise and lower the blinds/shutters. The
"Stop/step object" is used to adjust the slats. In addition, this function stops the up or down
movement if the end position has not yet been reached.
With the single-button function, the system switches between up and down after each button is
pressed. The direction is reversed depending on the "Status for change of direction" object. Since
blind actuators always use a 1 signal for the downward movement and a 0 signal for the upward
movement, the unit outputs this as well.
It is additionally possible to swap the action for the long and short button press.
The following table shows the available communication objects:
Number
Name/Object Function
131
Button left –
Blinds Up/Down
132
Button left –
Slats adjustment / Stop
133
Button left –
Status for change of direction
Table 37: Communication objects – Single-button function: Blinds/Shutter
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
46
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
Dynamic range
[Default value]
▪
long=move /
short=stop/slats Open/Close
▪
short=move /
long=stop/slats Open/Close
Length
1 Bit
1 Bit
1 Bit
Series .02
Comment
Setting whether to move or stop
with a long button or a short button.
Usage
Up/down command for the shutter actuator
Open/close slats and stop command
Receipt of the status with current information
about the direction of the shutter actuator
Advertisement
Table of Contents
