Basic Function - Send State - MDT Switch 55 Technical Manual

Technical Manual
Motion Detector/Automatic Switch 55/63
4.5.2.5 Basic function – Send state
 Single-button function
With the single button function: switch - subfunction: send state - fixed values can be sent for a
pressed button (rising edge) and a released button (falling edge). This function can be used to
implement triggering applications.
The following figure shows the available settings:
Figure 30: Settings – Single-button function: Send state
The following table shows the available settings:
ETS-Text
Value for pressed button
Value for released button
Cyclic sending
Send cyclically every...
Send state after bus power
return
Table 38: Settings – Single-button function: Send state
The following table shows the available communication objects:
Number Name/Object Function
131 Button left – Send state
Table 39: Communication objects – Single-button function: Send state
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
47
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
Dynamic range
[Default value]
▪
OFF
▪
ON
▪
OFF
▪
ON
▪
not active
▪
active
1 ... 3000 s
[300 s]
▪
not active
▪
active
Length Usage
1 Bit Sends the respective value when the button is
pressed and released
Series .02
Comment
Defines the sending behaviour of the
button.
Defines the sending behaviour of the
button.
Determine whether values are to be
sent cyclically.
Only if "Cyclic sending" is active.
Defines the distance between two
telegrams.
Specifies whether the current status is
to be sent after bus voltage return.