Technical Manual
Motion Detector/Automatic Switch 55/63
The following table shows the possible settings for this menu:
ETS-Text
Send „Operating" cyclically
Day/Night object
Value for Day/Night
Toggle Day/Night
Basic setting of sensitivity
Trigger sensitivity "Day"
Trigger sensitivity "Night"
Presence sensitivity
Basic setting of brightness
Switch-on threshold "Day"
Switch-on threshold "Night"
Switch-off if exceedance
Switch-off when exceeding...
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
12
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
Dynamic range
[Default value]
not active
•
1 min – 24 h
•
not active
•
active, not request
•
request after reset
▪
Day = 1 / Night = 0
•
Day = 0 / Night = 1
•
at next presence
•
directly at toggle
0 – 8
[6]
0 – 8
[3]
1 – 10
[8]
5 – 1000 Lux
[100]
5 – 1000 Lux
[10]
•
not active
•
active
75 – 1000 Lux
[800]
Series .02
Comment
Activation of a cyclic "in operation"
telegram.
Definition of whether a Day/Night
object is to be used and whether
this is to be requested in the event
of a reset.
Sets the polarity for Day/Night
switching.
Determining when the Day/Night
switchover takes place.
Setting the triggering sensitivity in
Day/Night mode.
Sensitivity 0 (lowest level) only
possible from DB V4.4 and from
device HW R2.5.
Setting the sensitivity when
presence is detected.
Setting of the brightness threshold
below which the sensor is activated
in Day mode.
Setting of the brightness threshold
below which the sensor is activated
in Night mode.
Setting whether an OFF telegram
should be sent when a certain
brightness threshold is exceeded.
Setting the brightness threshold
from when the sensor sends an
OFF telegram.