Table of Contents
Advertisement
DISASSEMBLY PROCEDURE
1 : Remove the battery cover, batteries and ink ribbon cassette.
2 : Remove 8 screws holding the lower cabinet and take it off.
(Refer to figure-11)
3 : Re-solder 6 wires from Buzzer and battery terminals.
4 : Remove 4 screws(A) holding PCB L271-1 and take out the connector CN3 on PCB L271-1.
5 : Take out FPC of chassis ass'y from PCB L271-2 and remove 2 screws(B) holding the PCB L271-2.
6 : Remove 10 screws(C) holding PCB L271-E4, 2 screws(D) holding the LCD and take off them.
7 : Remove 3 screws(E) holding the chassis ass'y and take off the chassis ass'y.
(E)
(Refer to figure-12)
8 : Remove a spring(X) and the tape fixing plate.
9 : Remove 2 screws(F) holding the scissors sub ass'y and a spring(Y).
10 : Take off the scissors sub ass'y.
Chassis
L271-E4
(C)
Upper cabinet
Figure-11
(X)
Tape fixing plate
Chassis ass'y (
Figure-12
(B)
CN3
L271-1
L271-
2
LCD
FPC
(Y)
(F)
= scissors sub ass'y)
— 12 —
(A)
(D)
Advertisement
Table of Contents
