Auto Clean Report
Figure 5-8 shows a sample of the auto clean report.
System
Off-line
Standby
Load Port
S
Stop
Figure 5-8. Report: Autoclean Status screen
When you have finished reviewing the report, press the Back button to return to the
Service screen.
Testing the Library
The Service screen provides the following testing command:
SYS TEST LIBRARY—This command lets you test library operation by swapping tape
cartridges between storage bins, drives, and load port.
NOTE: Do not perform this test if the cartridge position within the library is important.
Cartridges are not returned to their original positions during this test.
Back
Forward
Tapes
Report: AutoClean Status
Auto Clean Enabled:
Auto-Clean State:
Cleaning Operation Count:
Bad Operation Count:
Untracked Operation Count:
Last to Drive Error Status:
Last to Load Port Error Status:
Last to Home Error Status:
Home
Operator
Service
FALSE
Idle
0
0
0
0 00 00
0 00 00
0 00 00
Service Commands
5-9