Table of Contents
Advertisement
Displaying Devices within the Fabric
To verify that you have fabric wide connectivity when you install a new switch,
display the fabric wide fibre channel address list from the newly installed switch. Use
these steps to display the fabric.
1. Login to the switch as the admin user.
2. At the command line enter the following command:
nsAllShow
This command displays a list of fibre channel addresses for all devices in the
fabric.
Checking the Firmware Version
Use these steps to display the SAN Switch 2/8 EL firmware version.
1. Login to the switch as the admin user.
2. At the command line enter the following command:
version
This command displays the Kernel version, and Fabric OS release number.
Setting the Switch Date and Time
All switches maintain current date and time in non-volatile memory. Date and time are
used for logging events. Switch operation does not depend on the date and time; a
switch with an incorrect date and time value still functions properly.
Use these steps to set the date and time of a switch.
1. Login to the switch as the admin user.
Fibre Channel SAN Switch 2/8 EL Installation Guide
Managing the Fibre Channel SAN Switch 2/8 EL
3–11
Advertisement
Table of Contents
