Fujitsu BACnet UTY-VBGX Instruction Manual page 93

BACnet ® Gateway for VRF System
8.4.3 Fujitsu VRF
Set the Fujitsu VRF parameters
1. Unit Address: Enter the BACnet
within the same VRF network).
2. Temperature Mode: Enter the desired temperature units to be used (Celsius or Faherenheit).
3. Add Air Unit Manually: Use this option to introduce units manually in the configuration.
4. Scan Air Units:
Use this function to scan the VRF network automatically to look for the current units connected to the system.
Note: Scan may take from 5 to 6 minutes depending on each installation specs.
Figure 8.7 Fujitsu VRF interface configuration
® gateway unit address of LON (values from 92 to 95 with no duplication
Figure 8.8 Add units manually
Copyright© 2010-2017 Fujitsu General Limited - All rights reserved
INSTRUCTION MANUAL r1.3.2 eng
1
2
3
4
93/103