Fujitsu BACnet UTY-VBGX Instruction Manual page 91

BACnet ® Gateway for VRF System
Configuration
In this section is where main configuration for the signals is carried out.
8.4.1 General
Set the general gateway parameters.
1. Gateway Name: Descriptive name for the gateway in its use on the Configuration Tool.
2. Project Description: Short description of the project.
3. Enable DHCP: Enables and disables DHCP usage by the gateway.
4. IP: Enter the IP address for the gateway (192.168.100.144 by default).
5. NetMask: Enter the gateway net mask address (255.255.255.0 by default).
6. Gateway: Enter the router or default gateway address if needed. In case you don't want to use it, leave it
blank.
7. Password: Enter the access password to allow IP connection to the box (admin by default).
Figure 8.4 General configuration
Copyright© 2010-2017 Fujitsu General Limited - All rights reserved
INSTRUCTION MANUAL r1.3.2 eng
1
2
3
4
5
6
7
91/103