Table of Contents
Advertisement
BACnet
®
Gateway for VRF System
Connection
Use this section to configure the connection between the laptop or desktop to the gateway.
NOTE: If using IP connection, the Configuration Tool will automatically scan the IP network for the
gateway and will show it in the list. Notice that in that case, a password is required. Default values for
IP connection are: IP: 192.168.100.144 / Password: admin
If installing more than one BACnet
IP to each of them in case DHCP is not available.
Figure 8.2 Get Project from Device view
Figure 8.3 Connection configuration
®
Gatewy for VRF System, connect them one by one and assign an
Copyright© 2010-2017 Fujitsu General Limited - All rights reserved
INSTRUCTION MANUAL r1.3.2 eng
90/103
Advertisement
Table of Contents
