Install And Remove System Memory; Install So-Dimms - Intel NUC11PAQi7 User Manual

3.0

Install and Remove System Memory

Intel NUC Kits NUC11PAQi7, NUC11PAQi5 have two 260-pin DDR4 SO-DIMM
memory slots
Memory requirements:
• 1.2V low voltage memory
• 3200 MHz SO-DIMMs
• Non-ECC
Find compatible system memory modules at the Intel® Product Compatibility Tool:
•
NUC11PAQi7
•
NUC11PAQi5
3.1

Install SO-DIMMs

NOTE
To install the SO-DIMMs, follow these steps:
1. Observe the precautions in "Before You Begin" in Section 1.1.
2. Turn off all peripheral devices connected to the computer. Turn off the
computer and disconnect the AC power cord.
3. Align the small notch at the bottom edge of the SO-DIMM with the key in
the socket.
4. Insert the bottom edge of the SO-DIMM into the socket.
5. When the SO-DIMM is inserted, push down on the outer edge of the
SO-DIMM until the retaining clips snap into place. Make sure the clips
are firmly in place.
NUC11PAQi7, NUC11PAQi5
User Guide – January 2021
If you plan to install only one memory module, install it in the lower
memory socket.
8