Table of Contents
Advertisement
Oil Pressure
Figure 2 shows the compressor oil connections.
1. The oil pressure transducer is connected at the bottom of the oil solenoid sight glass
assembly (optional assembly shown in main diagram) or alternatively at the top of
the oil Tee fitting supplied on the compressor (shown in the exploded view to the
upper left of main diagram).
The oil solenoid sight glass assembly shown in Figure 2 is an optional item (P/N
EF12ZZ025), which can be purchased directly from Carlyle. The standard Oil Tee
fitting supplied on the compressor is also shown.
2. One of the compressor schraeder fittings (removed from either suction or discharge
access ports) should be installed at the end of the oil galley for oil pressure field
measurements.
Oil Solenoid/
Sight Glass
Oil Pressure
Transducer
(no special marking on
transducer)
Discharge Temperature
The discharge temperature sensor (Item 5) should be strapped to the discharge line as
close to the discharge service valve as possible (within 6" or less is optimal). Carlyle
recommends using thermoconductive grease to help insure accurate temperature
readings. The thermistor must then be wrapped with high temperature insulation such
as high temperature foam or cork insulation.
Motor Temperature
A 5 Kohm thermistor is embedded within the motor windings, and is located between S1
and S2 on the compressor electrical terminal plate. Leads should be extended from the
Carlyle Compressor Div.
Figure 2. Oil Fittings
P O Box 4808
Phone: 800-462-2759
6
Syracuse, NY 13221
Fax: 315-432-3274
Oil Press.
Access Ftg.
Advertisement
Table of Contents
