Nortek T6BQ-090 Series User Manual

Split system heat pump

Hide thumbs Also See for T6BQ-090 Series:

Download this manual

T6BQ- 090 (7.5 Ton) & 120 (10 Ton) Series

USER'S MANUAL

Split System Heat Pump - 2-Stage, 3-Phase, R-410A

• Under no circumstances should the appliance owner attempt to install and/or service this

equipment. Some local codes require licensed installation / service personnel for this type

of equipment. Improper service, adjustment, or maintenance may cause explosion, fire,

electrical shock or other hazardous conditions which may result in personal injury or property

damage.

• Read these instructions thoroughly before using the equipment. Follow all precautions and

warnings contained within these instructions and on the unit.

• Improper installation, adjustment, alteration, service, or maintenance can cause personal

injury or property damage. Refer to this manual. For assistance or additional information,

consult a qualified installer or service agency.

• Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any

other appliance.

DO NOT DESTROY. PLEASE READ CAREFULLY & KEEP IN A SAFE PLACE FOR FUTURE REFERENCE.

WARNING

11.0 EER / 12.7 IEER

Need help?

Do you have a question about the T6BQ-090 Series and is the answer not in the manual?

Page 1 T6BQ- 090 (7.5 Ton) & 120 (10 Ton) Series 11.0 EER / 12.7 IEER USER'S MANUAL Split System Heat Pump - 2-Stage, 3-Phase, R-410A WARNING • Under no circumstances should the appliance owner attempt to install and/or service this equipment. Some local codes require licensed installation / service personnel for this type of equipment.
Page 2 IMPORTANT SAFETY INFORMATION the unit and to replace any part of the electrical control system that has been under water. Please read all information in this manual thoroughly and • Familiarize yourself with the controls that shut off the become familiar with the capabilities and use of your appliance electrical power to the unit.
Page 3 Operating the Heat Pump for Automatic Cooling & Heating 1. Set the thermostat system switch to AUTO and the thermostat fan switch to AUTO. See Figure 1. 2. Set the thermostat temperature to the desired temperature level. The outdoor unit and the indoor blower will then cycle on and off in either the heating or cooling mode of operation as required to automatically maintain the indoor temperature within the desired limits.
Page 4 • Resetting circuit breakers or other switches. • Adjusting or calibrating of thermostat. Specifications & illustrations subject to change without notice or incurring obligations (01/18). 10131320 O’Fallon, MO, © Nortek Global HVAC LLC 2018. All Rights Reserved. (NEW)

T6bq-120 series