Rear Panel Description; Other Displays And Symbols - A&D AD-4405A Instruction Manual

ZERO key
CLEAR key
TARE key
ESC key
NET/GROSS key The key to select net or gross weight in the display.
+/- key
ENTER key
PRINT key
ON/OFF key
10 Printer cover
Printer

4.2. Rear Panel Description

11
No. Name
11 Power cord
12 Grounding terminal
13 Load cell connector
14 CAL key cover
15 Sealing panel
16 RS232C connector

4.3. Other Displays and Symbols

AD-4405A Weighing Indicator
The key to zero the current display.
The key to clear the setting value.
The key to perform tare.
The key to proceed to the next step without changing the
parameter set.
The key to select + or – of a value.
The key to confirm settings and store the values.
The key to print/output data.
Turns the display on and off (OFF: hold for 3 seconds).
Printer paper will be stored inside when the printer is installed.
Dot matrix printer (optional).
12
Connect to the AC power source.
Connect to the Earth (M4 size screw).
Connect a load cell using the accessory load cell plug.
The CAL key is located behind the sealing panel [15].
For type approval, available with the sealing wire posts.
Exchange this when installing other data output (Options).
Standby display.
Zero error when turning the display on. If the
pressed, the current weighing value may be displayed.
Overload display. Remove any load from the load cell
immediately. It may cause damage to the load cell.
An example of an error display.
Page 9
13 14
15
16
Description
4. Description of Panels and Symbols
key is
ESC