madVR Labs Envy User Manual page 17

In this case you can see the three values that we set. Notice that the indicator shows SET instead
of THRU. As we learned in Section 3.6.2, this indicates that the selected profile in the Profile Bar
is setting these values. Whether that ultimately becomes the value used in the Active Settings
depends on the profile being activated (in this case, a 4K signal needs to be present), and not
conflicting with any higher priority active profiles. Note that the values that we did not override
continue to show as THRU.
Next, recall we also want to have different Upscaling & Sharpening settings for 1080p signals. So,
we need to also create a new profile for 1080p and lower for this same menu page. Highlight the
Profile Bar, press the Green button, and add a new profile for 1080p or lower. The menu page
now looks like this:
Notice that our new values from above (3, 1, 4) show with the THRU tag. This indicates that the
currently selected profile (as shown in the Profile Bar) is not setting these values and these will
be unaffected by this profile, if not set here.
Now it is time configure the settings we want to assign for our 1080p and lower profile. Make
sure "Incoming Resolution: 1080p (or Lower)" is selected in the Profile Bar. Override these
settings to 4, Off and 5. As before, the indicators change to SET to show that the selected Profile
is "setting" these values, and the settings with THRU tags are unaffected. The menu page should
now look like this:
17
madVR Envy – Profile User Guide
Copyright © madVR Labs, LLC. All rights reserved.