madVR Labs Envy Barco Setup Manual
Hide thumbs
Also See for Envy:
- User manual (21 pages) ,
- Setup manual (11 pages) ,
- Sony setup manual (7 pages)
Related Manuals for madVR Labs Envy
Summary of Contents for madVR Labs Envy
- Page 1 Envy Barco Setup Guide www.madvrenvy.com Revision 1.02 madVR Envy – Barco Setup Guide Copyright © madVR Labs, LLC. All rights reserved.
-
Page 2: Configuration Steps
Introduction Welcome to the Envy Barco Setup Guide. Although setting up the Envy itself is often as simple as plugging in the HDMI cables and entering the projector’s peak brightness, it is important that your projector be set optimally for use in conjunction with the Envy. This guide covers the recommended set up for Barco projectors when used with Envy. - Page 3 Contrast 1, Saturation 1, Gamma Type “Power” with a value of 2.4, Sharpness 0, and Brilliant Color (select models only) to Off. See the example shown on the next page. madVR Envy – Barco Setup Guide Copyright © madVR Labs, LLC. All rights reserved.
- Page 4 “Base Settings” from the bottom of the menu. a. If you will not use a 3D LUT, you must set the Envy Transfer Function value to 2.4, to match the Gamma value in the Barco, as configured step #2. If you used a different Gamma setting in the prior step, set that value in the Transfer Function here, rather than 2.4.
- Page 5 4, the Envy will then map BT.2020 and BT.709 content to DCI-P3, which the Barco will display as such. This way the Barco will always remain in the DCI-P3 color space (which has advantages over it switching between BT.709 and BT.2020 otherwise), while maintaining proper color accuracy.
- Page 6 6. For the most accurate color, grayscale, and gamma tracking we recommend performing a 3D LUT. If you do so, please skip step 3 (Envy ignores those settings when a 3D LUT is active). In step 4, select “Uncorrected” instead of “DCI-P3-D65”. In step 5, select “Native” instead of “HDR”.
- Page 7 Bragi will show 5120x2160). In some cases, when first pairing the Envy with the Barco, the projector may connect at 1024x768. If this happens, please check step 1 above and make sure the setting is changed in the Envy Base Settings and not Active Settings so that the setting is saved.
-
Page 8: Additional Resources
E. On the Outgoing Signal Information menu, make sure the Outgoing Transfer function shows “SDR”. This should always be the case with the Envy, even for HDR. This is because the Envy does the HDR processing and then outputs its signal as SDR (but still delivering an HDR image).