Float Valve And Silicone Cap; Condensation Collector - Instant Pot Duo Plus 30 v2 Get Started

Care, cleaning and storage

Float valve and silicone cap

Remove the float valve
Place one finger on the flat top of float
valve, then turn the lid over. Detach the
silicone cap from the bottom side of the
float valve. Remove the float valve from
the top of the lid.
Do not discard the float valve or
silicone cap.
Install the float valve
Drop the narrow end of the float valve into
the float valve hole on the top of the lid.
Place one finger on the flat top of the float
valve, then turn the lid over. Firmly attach
the silicone cap to the bottom of the
float valve.
Do not attempt to operate the multi-
cooker without the float valve and/or
silicone cap properly installed in the multi-
cooker lid.
Illustrations in this document are for reference only and may differ from the actual product.
40 | support@instantpot.com.au | 1800 251 643

Condensation collector

The condensation collector sits at the back
of the multi-cooker base and catches any
overflow from the condensation rim.
It should be installed before cooking, then
emptied and rinsed out after each use.
Remove the condensation collector
Pull the condensation collector away from
the multi-cooker base; do not pull down.
Note the tabs on the multi-cooker base
and the grooves on the condensation
collector.
Install the condensation collector
Align the grooves on the condensation
collector over the tabs on the back of
the multi-cooker base and slide the
condensation collector into place.
Always refer to the actual product.