Advertisement
SEAT POST ROUTING
STA AR SET P
01.
With a 3mm allen key, remove the lower
cable port access cover near the bottom
bracket.
03.
Use your finger to help push the
housing around the bend in the frame
up into the seat tube.
PAR TOOL SET P
01.
Remove the lower cable port access
cover with a 3mm allen key.
13
02.
Install your seatpost housing into the
head tube port, pushing until it exits near
the lower cable port access hole.
04.
While pushing the housing into the head
tube port, continue pushing the cable
up the seat tube through the access
port until the housing exits the seat
tube.
02.
Drop a Park Tool Router tool down
the seat tube until it exits the access
port.
03.
Push your seatpost housing into the frame
from the headtube port until it exits near the
access port.
05.
Pull router tool back through the frame
until your housing exits the seat tube.
01. Y RA LIC SET PS
Route a section of shifter housing through the
frame using the steps described in Standard
Setups. Connect
the
double-barb
to
the
shifter housing and the seatpost housing
at the seat tube.
BRA E
Push the brake line into the frame starting at the
rear triangle, feeding it forward to the ports into
the front triangle and out the head tube.
04.
Outside of the access port, connect
the Park router tool to the housing.
02.
At the same time, pull the shifter housing
out of the head tube port while pushing the
seatpost housing into the seat tube until
the double barb exits the head tube.
S IFTER
Push the shifter housing into the lower
head tube port on the non-drive side.
Feed the housing back to the ports on
the rear triangle and eventually out near
the drive-side dropout.
14
Advertisement
