Advertisement
A S S E M B L Y
05.
Install the Switch Infinity Link into the frame by
rocking it into place over the bolts and black
Switch Washers. The grease zerks should face
the non-drive side. Tighten the 4x bolts by
hand, then tor ue in a cross pattern to
Nm
07.
Place the Upper and Lower Extenders together so that the bearings touch in the middle. Orient the Upper
threaded extender toward the top and slide into the Link
19.
06.
Apply a light coat of grease to the inner
surfaces of x Extender Bearing Races
300040505 . Place one each into the Upper
and Lower Shock Extenders
000 03
and
000 03 3 .
000 03 1 . Secure with a uide Pin.
0 .
Slide a 41mm Titanium Female bolt with Washer 300030069 through the Link/Extender
Assembly. Secure with a Ti Male Bolt 300030151
with Blue 243 Loctite.
*Torque to 10 Nm.
0 .
rease shaft of the Link Pivot Female Bolt
000 03 8 . Place the Link onto the Front
Triangle as shown and secure with Link Pivot Female Bolt.
Bolt 300030 93 prepped with Blue 243 Loctite.
*Torque to 15 Nm.
A S S E M B L Y
Washer 30003006
prepped
Install Link Pivot Male
20.
Advertisement
