Advertisement
A S S E M B L Y
10.
Apply a light coat of grease to the Rear Triangle in the Main Pivot bores and lightly grease the shaft of
the Main Pivot Collet Axle 300040485 and prep the threads with Blue 243 Loctite. Slide the Rear
Triangle over the Switch Infinity Link and install Main Pivot Collet Axle 300040485 through assembly.
Install Collet Nut 300030 85 and tighten Axle until any play is removed.
*Torque to rou
12 Nm
11.
rease threads and wedge of Large Collet
Wedge Bolt 300040454 . Install into the Main
Pivot Axle and Torque to
Nm
21.
12a.
rease shaft of x Seatstay Pivot Female Bolt
000 03 6 . Install one Seatstay Pivot Female
Bolt
000 03 6 through the Rear Triangle
and into the link.
12 .
Rotate Swingarm Forward and move Upper and
Lower Shock Extenders out of the way.
Install one eyed Bolt
000 03
prepped
with Blue 243 Loctite from the inside of the link,
threading the Female Bolt onto it. Draw the
eyed Bolt into assembly and make sure its key
nests into the keyway on the Link bore.
13.
Open the Upper and Lower Shock Extenders
and position the Shock into the frame, allowing it
to sit between the two Extender aws. Secure
front eyelet with a uide Pin
A S S E M B L Y
12 .
Tor ue Seatstay Pivot Female Bolt to 6 Nm
Repeat process for opposite side.
14.
Install Collet Axle 300030 96 from the Lower
Extender through the Shock and threading into
the Upper Extender. Prep threads with Blue
243 Loctite and grease the shaft.
*Torque to 3 Nm
22.
Advertisement
