Yeti SnowMX CARGORAK Installation Procedure

YETICAN MOUNT
CARGORAK MOUNT
Centre on bumper screw
7/32 Bit
Foam Blocks
INSTALLATION PROCEDURE
Our Cargo Rack is built with strong CNC aluminum
channels . There are three available sizes that match
to the length of your YETI.
To assemble your "CARGORAK" follow these instructions
or refer to our website at: www.yetisnowmx.ca
CARGORAK
1. Make sure that the YETICAN mount is already installed. You
cannot install the cargo rack without the YETICAN mount.
2. Insert the rear cargo rack plastic mount provided over the two
rear brackets and secure it with both"Quick pins".
3. Position the CARGORAK front into the YETICAN installed front
mount.
4. Centre the CARGORAK rear plastic mount to the centre screw
on the bumper for reference.
5. Using a Sharpie trace the edges of the mount onto the chassis
6. Peel back the sticky foam pad and position it within the mark-
ings you just made
7. Drill through holes in foam with a sharp 7/32" bit.
8. Secure the mount with the screws provided in the package
using blue Locktite.
10. Peel and insert the small foam blocks in the depressions of
the rear cargo mount.
11. Remount your CARGORAK and secure it with the "Quick
pins" provided.
INSTALLATION