Advertisement
FRAME ASSEMBLY
YETI TIPS
Make sure your tools are in good condition.
A worn allen key can round the hex on a
bolt not allowing for proper torque.
Torque settings are listed throughout the
instructions. It is important to prep all bolt
threads. The instructions denote whether to
use a Loctite compound or grease.
Warning: Service on Yeti bicycles requires special
knowledge and tools. Yeti Cycles recommends that all
service and repairs be performed by an authorized Yeti
Dealer
17.
TOOLS EE E
• 3mm allen key
• 4mm allen keys
• 5mm allen keys
6mm allen key
•
• 10mm allen key
• Guide pin tool (Or two)
Cassette tool
•
• Torque wrench
• Grease
• Blue (243) Loctite
01.
All the parts you'll need to get your SB130/LR
frame assembled. Please refer to the exploded
view later in this manual for more information.
03.
Apply a light coat of grease to the threads of the
Rear Triangle at the Seat Stay Pivots. Install x
Bearing Lockring (200020311) with a cassette tool.
*Torque to 20 Nm.
02.
Press the Shock Eyelet Spacer into the rear
shock eyelet using an arbor press or vise.
04.
Slide 4x Washer 300030 14 over 4x M6 Cap
Screw (3000300
) and apply Blue Loctite
43
or similar to the threads.
Insert the 4x Cap Screws into the frame and
place a black Infinity Link washer on each bolt.
Orient the washers such that the flat surfaces are
facing the window in the frame where the Switch
Infinity Link is mounted.
18
Advertisement
