Advertisement
MATERIALS:
FDA approved blow-molded high-density polyethylene with Microban
with nylon safety straps that extend over child's shoulders and between legs for security.
OPERATION:
Designed to mount on the wall of a restroom stall or a dressing room. Closed unit folds to less than 6" (143mm), and
requires less than 2 sq. ft. (600 sq. cm) of wall space. High-density polyethylene is easy to clean and resists fungal and
bacterial growth. Can withstand static loads of 150 lbs (68 kilos).
Warning: To insure that the unit supports the intended loads, seat must be properly installed according to the
manufacturer's instructions.
INSTALLATION:
To insure proper installation and compliance with building codes, it is recommended that a qualified person or carpenter
perform the installation of the unit. The Child Protection Seat must be properly installed onto wall or partition of restroom
or fitting room that is capable of supporting significant weight and can accommodate the supplied installation hardware
(or other suitable hardware, not included, if unit is to be installed on another type of wall such as a cinderblock or
permanent wall).
Drilling holes and mounting the station:
1. Remove the unit from the shipping container and check for any freight damage. Identify the best location for
installing the Child Protection Seat. Hold the unit in place, open the seat, and make sure that there is adequate
operating clearance. Use the seat as a template for locating the four mounting holes onto the mounting surface.
Seat bottom should be 2" (51mm) from bottom of wall/partition or 14" (356mm) from the floor, whichever is higher.
2. The Child Protection Seat has four mounting holes provided in the back wall of the unit, which are positioned
8" (203mm) apart horizontally and 17" (432mm) apart vertically. Hardware included with unit is intended for
installation of seat to a restroom or fitting room partition. If Installing onto another wall type separate hardware will
be required (not included).
3. Drill through partition using 3/8" (10mm) drill bit.
4. Insert the four threaded plugs with head holes (supplied) from the outside of the partition.
5. Mount the Child Protection Seat with the four 1/4" (6mm) screws and washers (supplied).
6. Place the label/decal on the outside of stall or fitting room door.
SPECIFICATION:
Child Protection Seat body shall be durable, high-density polyethylene. Design of unit shall be surface-mounted. Seat
shall be secured to back plate with a concealed, full-length stainless steel hinge rod embedded in the plastic. Seat shall
have nylon safety straps. Unit shall support static loads of up to 150 lbs (68kg) when properly installed. Unit shall be
backed by a 5-year manufacturer's limited warranty on materials and workmanship and a 5-year replacement warranty
against vandalism. Unit shall be manufactured in the U.S.A.
Baby Changing Station shall be model KB102-00-INB of Koala Kare Products, A Division of Bobrick
6982 S. Quentin St. Centennial, CO 80112 USA
Tel: 1-888-733-3456 within the USA or +1 303-539-8300 outside the USA
Web: www.koalabear.com or www.bobrick.com
The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet.The manufacturer
reserves the right to, and does from time to time, make changes and improvements in designs and dimensions without notice.
. Stainless steel hinge rod. Textured seat surface
®
KB102-INB
© 2007 by Koala Kare Products, A Division of Bobrick
Revised 12-12-07
Printed In USA
Advertisement
