Advertisement
MATERIALS:
FDA approved thermoformed high-density polyethylene. Mounting instructions and hardware included. Contoured
changing surface area is 379.04 sq. in. (244,541.45 sq. mm) comes complete with nylon safety straps.
OPERATION:
For use in restrooms where counter space is more abundant than wall space. High-density polyethylene has no sharp
corners, is easy to clean and resists odors and bacterial growth.
Warning: To insure that the unit supports the intended loads, baby changing stations must be properly installed
according to the manufacturer's instructions.
INSTALLATION:
To insure proper installation and compliance with building codes, it is recommended that a qualified person or carpenter
perform the installation of the unit.
Drilling holes and mounting the station:
1. Remove the station from the shipping container and check for any freight damage. Identify the best location for
installing the baby changing station.
2. Place the countertop BCS onto the counter surface and place in desired position. Using the countertop BCS
mounting holes as a guide, mark the screw hole locations with a pencil. Remove countertop BCS and drill holes
with a #21 or 5/32" drill bit. Drill down 1-1/2" (32mm) deep.
3. Apply a suitable water sealant, such as silicone, around the bottom edge of the changing station, then set unit
onto the countertop using the mounting holes as a guide. Fasten unit to countertop with supplied screws.
Caution:
Drill carefully through ceramic tile and other hard countertop materials.
SPECIFICATION:
Baby changing station shall be durable, high impact polyethylene body. Design of unit shall be countertop surface
mounted. Bed shall have smooth concave changing area with a nylon safety strap and universal instruction graphics.
The unit shall be backed by a 5-year manufacturers limited warranty. Unit shall be manufactured in the U.S.A.
Baby Changing Station shall be model KB112-01CT-INB of Koala Kare Products, A Division of Bobrick
6982 S. Quentin St. Centennial, CO 80112 USA
Tel: 1-888-733-3456 within the USA or +1 303-539-8300 outside the USA
Web: www.koalabear.com or www.bobrick.com
The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet.The manufacturer
reserves the right to, and does from time to time, make changes and improvements in designs and dimensions without notice.
KB112-CT-INB
Revised 12-12-07
Printed In USA
© 2007 by Koala Kare Products, A Division of Bobrick
Advertisement
