Koala Kare KB100-ST Installation Instructions

Horizontal Recessed Mounted Baby Changing Station
KB100-ST and KB110-SSRE
INSTALLATION INSTRUCTIONS
Please Note:
To assure proper installation,
it is suggested that a qualifi ed
person or carpenter install the
Koala Baby Changing Station.
Koala Kare Products will not
be responsible if the station is
not installed properly.
Koala Baby Changing
Stations have been tested
to hold a substantial static
load. The unit must be
attached to a permanent wall
that is capable of holding a
substantial load.
You are responsible for the safe operation of this unit.
Inspection Criteria:
A properly maintained unit:
• Opens and closes smoothly.
• Has both ends of a functioning, non-frayed
strap: buckle clicks when closed and strap is
attached at both ends of the unit.
• Offers parents liners through a fully stocked
liner dispenser. (Dispenser is built into unit.)
• Provides a clean, convenient place for
customers to attend to their children.
Tools Needed:
• Measuring Tape
• Level
• Flat Head and Phillips
Screwdrivers
• Stud Finder
• Pencil
• Drill
• 7/32" (.56 cm) Drill Bit
(regular and masonry)
• 1/8" (.32 cm) Drill Bit
(regular and masonry)
• ½" (1.27 cm) Drill Bit
(regular and masonry)
•
•
•
•
•
•
•
•
•
•
Hardware Supplied:
• Four ¼" x 3" (.64 cm x 7.62
cm) Panhead Wood Screws
• Four ¼" x 3" (.64 cm x
7.62 cm) Phillips Panhead
Machine Screws
• Four ¾" x ¼" (2 cm x .64
cm) Hole Washers
• Four Toggles
• One Restroom Sign
Horizontal Strap (885)
Horizontal KB100-ST Gas Shock (874)
Horizontal KB110-SSRE Gas Shock (875)
Cream Horizontal Liner Dispenser Lid (829)
Grey Horizontal Liner Dispenser Lid (828)
Koala Restroom Door Decal (841)
Warning Label (975)
Cream Unit End Caps (692)
Grey Unit End Caps (850)
Box of Liners (KB150-99)