Emerson E2 Quick Start Manual page 8

STEP 5: Commissioning the Device into the E2 Controller
 
1. Press ,
2. On the Network Summary screen, highlight the device name, press
preferred MODBUS port where you will assign the device, then assign the MODBUS address of the
device.
Document Part # 026-4953 Rev 0 07-NOV-2014
©2014 Emerson Climate Technologies Retail Solutions, Inc. This document may be photocopied for personal use.
Visit our website at http://www.emersonclimate.com/ for the latest technical documentation and updates.
(System Configuration),
Figure 10 - MODBUS Device Address Selection
 
(Network Setup), (Network Summary).

(COMMISSION). Select the
Page 8 of 9