Key Functions; Video Switching - Hall Technologies HT-ATLAS User Manual

Key Functions

The device offers multiple functions such as Video switching, automatic signal switching,
Guide Screen and OSD, allowing for easy control on the system.

VIDEO SWITCHING

The device supports full screen and split screen, as shown in the following figure.
1. When BYOD is set to OFF, it is only working as full screen, and can switch sources between
HDMI IN /USB Type-C / Type-C HT-Voyager, it will follow the rule: "Last-in-first-out":
• When a video source inputs, the device automatically switches to this source and output
it.
• When the current source input is removed, the device switches to the active hardware
video source most recently connected or selected. If there's no active source connected,
the device outputs Guide Screen picture finally.
Note:
• You can switch HDMI IN/Type-C source via plug/unplug cable or pressing button on top
panel.
• During switching sources, the USB device is always bound with the selected source.
2. When BYOD is set to ON, the device supports switching among all sources.
• When one source is connected to the device, the device is in full screen mode.
• When two or more sources are connected to the device, the device is in split screen and
the latest inserted source will replace the earliest connected source to show in the
corresponding split screen.
• When remove the source selected currently:
o
Firstly, check the last selected wired source, if it is active, the device will switch to
the source and show it on the screen.
Hall Technologies August 22, 2022 Page 9 of 30