Key Functions; Video Switching - Hall Technologies HT-ODYSSEY User Manual

Key Functions

The device offers multiple functions such as video switching, automatic signal switching,
Guide Screen and OSD, allowing for easy system use.

VIDEO SWITCHING

The device supports full screen and split screen, as shown in the following figure.
1. When BYOD is set to OFF, the HT-ODYSSEY only works as full screen, and can switch sources
between HDMI IN /USB Type-B / USB Type-C and HT-Voyager and will follow the rule: "Last-
in-first-out":
• When a video source is connected, the device automatically switches to this source and
outputs it.
• When the current video source is disconnected, the device switches to the active video
source most recently connected or selected. If there's no active source connected, the
device outputs the Guide Screen picture.
Note:
• You can switch HDMI IN/Type-C source by plugging or unplugging the cable, or by
pressing the Source Switch button on the top panel.
• When switching sources, the USB device is always bound with the selected source.
2. When BYOD is set to ON, the device supports switching among all sources.
• When one source is connected to the device, the device is in full screen mode.
• When two or more sources are connected to the device, the device is in split screen and
the latest inserted source will replace the earliest connected source to display in the
corresponding split screen.
• When the currently selected video source is disconnected:
o
First, the device checks the last selected wired source. If the source is active, the
Hall Technologies November 8, 2022 Page 9 of 30