Setup And Installation; Hardware Setup; Insert A Usim Card (Umts Modules Only) - Sierra Wireless MC5720 Quick Start Manual

M i n i C a r d U n i ve r s a l D e v e l opment Kit Quick Start Guide

Setup and installation

To begin using the UDK with your development system, you need to:

Hardware setup

Insert a USIM card (UMTS modules only)

To use a UMTS module (MC87xx), you need to install a USIM card (with an
active UMTS account).
6
Set up the hardware
•
Insert a USIM card (UMTS modules only)
•
Insert the Mini Card (page 7)
•
Connect the antenna(s)
•
Connect the power supply and USB cable
•
Configure the module
Set up the software
•
Install/update drivers (page 12)
•
Install Watcher (page 14)
1. Place the daughterboard face-down – the USIM slot is at the opposite
end from the antenna connection.
2. Open the USIM casing – the casing latches in place, so you may have to
push the tab marked "LIFT" slightly to the side before lifting it.
(page 6)
(page 8)
(page 10)
(page 10)
2 1 3 0 6 7 7