Advertisement
Operating Instructions
Worksteps for unlocking/removal
(1) Press the two "PUSH" keys simultaneously to open the lock (Figure 2).
Figure 2
Worksteps for mounting / snapping on
Figure 3
Reading range of the RFID snap-on module
Reading range
Distance
LF reader
up to 6.0 cm
HF reader
up to 6.0 cm
The reading range depends on factors such as, for example:
-
tag size
-
site of installation (metal, wood or other supporting surface)
-
ambient conditions
-
magnetic influences from outside
-
temperature
-
moisture
BARTEC GmbH
Max-Eyth-Straße 16
97980 Bad Mergentheim
Germany
RFID Snap-on Module
(Translation)
for Mobile Computer MC 959x Series
(1) Push the RFID snap-on
module with latch downwards
onto the indentation on the
back of the mobile computer.
(2) Press the RFID snap-on
module in until the latching
hook clicks into place (Fig. 3).
Reading range
Distance
UHF (EU) reader
up to 30.0 cm
UHF (US) reader
up to 30.0 cm
Tel.: +49 7931 597-0
info@bartec.de
Fax: +49 7931 597-119
www.bartec.de
Software Version - RFID SDK
The software is not relevant for the explosion protection for the
devices. You will find information on this in the documentation relating
to the RFID SDK on the CD or on the BARTEC download page.
BARTEC download page:
http://www.bartec.de/automation-download/
Final inspection
The following preconditions must be checked before putting the device
into operation:
Is there any damage to the enclosure?
Is the correct RFID snap-on module for the Mobile Computer snapped
on?
Has the software been installed?
Do not switch on the Mobile Computer with snap-on module until you have
completed the final inspection.
7. Malfunctioning and Troubleshooting
In the event of malfunctioning, take the Mobile Computer with the
RFID snap-on module out of the hazardous area.
Malfunctioning
Possible Cause
No power supply.
RFID tags are
not detected.
Incorrect standard set
Tag defective
The snap-on module has
not snapped on correctly.
RFID
demonstra-
tion software
Software does not react
is not detected
and identified.
Software has not been
installed correctly
The RFID snap-on module is only ready for operation if it is snapped
on and the software has been installed.
Remedying the software installation
(1)
Unlock and remove the snap-on module.
(2)
Uninstall all files on the Mobile Computer for the RFID reader.
Start
=>
Settings
=>
(3)
Connect the mobile computer via a cradle to the PC.
(4)
Install the demonstration software on the Mobile Computer.
(5)
Take the Mobile Computer out of the cradle and switch it off.
(6)
Snap the RFID snap-on module onto the Mobile Computer.
(7)
Switch on the Mobile Computer.
(8)
Call up the RFID demonstration in the Start menu.
(9)
The RFID Software automatically initialises and detects the snapped on
RFID snap-on module.
Reservation Technical data subject to change without notice. Changes, errors and
misprints may not be used as a basis for any claim for damages.
Remedy
Release and latch the
snap-on module on again.
Select the right standard in
the software setting.
Test another RFID tag.
Unlock and snap on the
snap-on module again.
Perform a cold boot on the
Mobile Computer by
simultaneously pressing
the "Power" and 1 and 9)
Uninstall the software and
re-install it again.
Remove
=>
System
=>
Programs
=>
=>
4/5
Advertisement
