Programming Instructions - Ecowood FI 3 DUAL Installation, User’s And Maintenance Handbook

FI 3 FI 4
DUAL -
UK

PROGRAMMING INSTRUCTIONS

The fire must be extinguished when the clock and automatic ON/OFF cycles are programmed in
the stove.
1. To enter programming, press the ON/OFF and MAN/AUTO buttons one after the other and keep
them both pressed for a few moments, then release them together.The display will show the
message PR.
2. Press the + button followed by the ON/OFF and MAN/AUTO buttons one after another, so that
time is displayed.
3. Press the - button followed by the ON/OFF and MAN/AUTO buttons one after another, to dis-
able the time display.
4. Press MAN/AUTO to set the clock.
5. Press ON/OFF to set the automatic ON/OFF cycles for the stove.
6. To exit programming, press ON/OFF and then MAN/AUTO immediately afterwards.
SETTING THE DATE AND TIME
1. To enter programming, press the ON/OFF and MAN/AUTO buttons one after the other and keep
them both pressed for a few moments, then release them together.The display will show the
message PR.
2. Press MAN/AUTO to set the clock (the first digit on the left in the "H" display will flash).
3. Press the + button to increase the flashing value; if you press the - button you will shift to
the previous display.
4. To enter and confirm each setting, press the ON/OFF button; every time you confirm a setting
the next display will start to flash.
Continue programming the settings for the hour "H" and minutes "M" and then programme
the current day of the week "D" (e.g. 1=Monday; 2=Tuesday; 7=Sunday).
When you have finished programming (after selecting the last number on the right in the "D"
display, the message PR will reappear.
5. To exit programming, press ON/OFF and then MAN/AUTO immediately afterwards.
PROGRAMMING AUTOMATIC ON AND OFF TIMES
1. To enter programming, press the ON/OFF and MAN/AUTO buttons one after the other and keep
them both pressed for a few moments, then release them together.The display will show the
message PR.
36
2. Press ON/OFF to set the automatic ON/OFF cycles for the stove.
3. Display "D" will show the number for the day that is to be programmed or modified: (e.g.
1=Monday; 2=Tuesday; 7=Sunday). Press the + button to select the day you want to pro-
gramme.
After selecting the day, press the ON/OFF button to continue programming the times when the
stove will be switched on and off.
When the red LED is lit this means you are programming when the stove is to be switched on.
Set the automatic switch-on time using the same procedure as given in the section on "Setting
the date and time".
4. After completing programming for switch-on time, press the ON/OFF button to go on to pro-
gramme the time when the stove will be switched off.The green LED will come on to indicate
that you are programming when the stove is to be switched off.
Set the automatic switch-off time using the same procedure as given in the section on "Setting
the date and time".
5. Press the ON/OFF button to enter and confirm the cycle settings you have just made.
It is possible to programme up to 4 automatic ON/OFF cycles per day; the yellow LED's indi-
cate which cycles have been programmed.
It is not possible to switch ON or OFF at 00:00.
6. To exit programming of the ON cycles, press the MAN/AUTO button while the first number on
the left in the "H" display is flashing.
7. To completely exit programming, press the ON/OFF button and then the MAN/AUTO button im-
mediately afterwards.
PROGRAMMING WITH THE REMOTE CONTROL:
Follow the same procedures as described above.
REAR AIR DISCHARGE FUNCTION
To use rear air discharge, take into account the fol-
lowing recommendations:
When the stove is used with a closed butterfly valve,
the power selector should not be set higher than
third speed to avoid overheating, causing the heat
safety switch to activate. The switch can be found to
the right, at the rear inside the stove.
If this happens, the user must wait until the stove
cools down to a temperature less than 93°C so as to
be able to reactivate and ignite the stove again.
FI 3 FI 4
DUAL -
(FI 3 DUAL)
UK
37