Identification Of Your Equipment4; Serial Number; Abbreviations - Honeywell HERMetic UTImeter Gtex Chem IIC Operation And Service Manual

2.1. Serial number

Each HERMetic instrument
identified with a 6 digits serial number starting
with the letter G, example G10058. This serial
number is printed on the identification plate that is
located on top of the handle. See Figure 2-1.

2.2. Abbreviations

Some abbreviations are used to define the equipment. Refer to following table and to Figure 2-2.
Abbreviation
ETCE
FFKM
FKM (Viton)®
Gtex
Gtex Chem
Gtex Chem Reflon IIC
NBR
PA 11 (Rilsan®)
PE
PEHD
PFA
PTFE
Q1
Q2
SS1
SS2
TEFZEL®
ULTRA
UTI
Visc
50489/GTEX Chem IIC/1805
2. Identification of your equipment
is
individually
Meaning
Special PTFE used for extruding
Perfluoro rubber, special for chemical applications
Fluoro rubber for crude oil and some products applications
Gas tight mechanical housing for non corrosive liquids, i.e. with FKM gaskets
and PA 11 coating (blue)
Gas tight mechanical housing for corrosive liquids, i.e. with FFKM gaskets and
PA 11 coating (blue)
Gas tight mechanical housing for corrosive liquids, i.e. with FFKM gaskets and
FEP coating (black or green) to protect aluminium against liquids
Acrylonitrile-butadiene rubber (nitrile rubber)
Polyamid coating (blue, grey, or yellow) used for protecting aluminium against
liquids
Polyethylene
Polyethylene High Density
Perfluoro alkoxyl alkane
Polytetrafluoroethylene
Connector 1"
Connector 2"
Stainless steel Storage tube 1"
Stainless steel Storage tube 2"
ETFE coating of the tape
Ultrasonic sensing probe, second generation, covering a wide range of liquids
from crude oil to light products, chemicals and heavy/viscous liquids
Stands for: U (ullage), T (temperature), I (oil/water interface)
Additional load on the sensing probe for innage measurement or gauging
viscous liquids
4
Identification plate
Figure 2-1
UTImeter Gtex Chem IIC