Canvac Q Air CFK5301V Use Instructions page 14

14
GB
Thermostat function (Warm mode)
1. Press the Warm mode button and the LED Display shows the ambient
temperature.
2. Press +/– temperature button, the temperature display on the LED Display will
flash, and the user can set the desired temperature (1–30°C).
3. 10 seconds after the desired temperature is set, the LED Display will stop flashing
and show the ambient temperature.
• The temperature being set should be higher than the ambient temperature, so
that the heating function will be turned on.
• When the ambient temperature reaches the set temperature, the heating function
will stop and the airflow will be reduced to the minimum setting.
• When the ambient temperature drops below the set temperature, the heating
function will automatically be reactivated.
Note:
• The default temperature is set at 25°C.
• The appliance will only run for 12 hours in Warm mode, and will then turn off
automatically. Restart by pressing the On/Off Button on the main body or the
Remote Control.
© 2022, Elon Group AB. All rights reserved.