Static Router Port Configuration - H3C S5500-SI Series Manual

Operation Manual – Multicast Protocol
H3C S5500-SI Series Ethernet Switches
As shown above, GigabitEthernet1/0/3 and GigabitEthernet1/0/4 of Switch A have
joined IPv6 multicast group (ff1e::1).

2.8.2 Static Router Port Configuration

I. Network requirements
No multicast protocol is running on Router B. After the configuration, Switch A should
be able to forward IPv6 multicast data to Router B.Figure 2-4 shows the routernetwork
connections.
II. Network diagram
Source
Figure 2-4 Network diagram for static router port configuration
III. Configuration procedure
1) Configuring a VLAN
# Create VLAN 100.
<SwitchA> system-view
[SwitchA] vlan 100
# Add ports GigabitEthernet1/0/1 through GigabitEthernet1/0/4 into VLAN 100.
[SwitchA-vlan100] port GigabitEthernet1/0/1 to GigabitEthernet1/0/4
[SwitchA-vlan100] quit
2) Configuring a static router port
# Enable MLD Snooping in VLAN 100.
[SwitchA] mld-snooping
[SwitchA-mld-snooping] quit
GigabitEthernet1/0/3
GigabitEthernet1/0/4
RouterB
GE1 /0/4
GE 1/0 /1
GE 1/0 /2
RouterA
IPv6 Multicast Packets
Chapter 2 MLD Snooping Configuration
Internet
Sw itchA
GE 1/0/3
Receiver
HostB
HostA
2-22