Configuring Source Ipv6 Addresses Of Mld Queries; Configuring An Mld Snooping Policy; Configuration Prerequisites - H3C S5500-EI Series Operation Manual

Operation Manual – Multicast
H3C S5500-EI Series Ethernet Switches
Configure the MLD
last-member query
interval
Caution:
Make sure that the MLD query interval is greater than the maximum response time for
MLD general queries; otherwise undesired deletion of IPv6 multicast members may
occur.

3.5.4 Configuring Source IPv6 Addresses of MLD Queries

This configuration allows you to change the source IPv6 address of MLD queries.
Follow these steps to configure source IPv6 addresses of MLD queries:
Enter system view
Enter VLAN view
Configure the source IPv6
address of MLD general
queries
Configure the source IPv6
address of MLD
multicast-address-specific
queries
Caution:
The source IPv6 address of MLD query messages may affect MLD querier election
within the segment.

3.6 Configuring an MLD Snooping Policy

3.6.1 Configuration Prerequisites

Before configuring an MLD Snooping policy, complete the following tasks:
To do...
mld-snooping
last-listener-query-inter
val interval
To do...
system-view
vlan vlan-id
mld-snooping
general-query source-ip
{ current-interface |
ipv6-address }
mld-snooping
special-query source-ip
{ current-interface |
ipv6-address }
Chapter 3 MLD Snooping Configuration
Use the command...
Use the command...
3-15
Remarks
Optional
1 second by default
Remarks
—
—
Optional
FE80::02FF:FFFF:FE00:0
001 by default
Optional
FE80::02FF:FFFF:FE00:0
001 by default