Table of Contents
Advertisement
SET-UP
·
Pull and turn the E-STOP clockwise-CW to energize the machine.
·
The AUTO-FILL button is Enabled (shown as a blue button) on the START SCREEN
and will fill until the main tank is completely full to the level of the overflow weir and
the weir tank level sensor is activated. The AUTO-FILL level sensor is located 18"
from the bottom of the weir tank.
·
Manually lift the lid open. The lid comes equipped with gas assist hinges.
·
Manually fill the tank with the proper ratio of soap.
·
Using hot water will shorten the amount of time required to heat the water. Check
drain assembly to insure there is no leakage.
·
To set Temperature Set Point, Sonic Cycle Time and Agitation Cycle Time, Press
SETUP SCREEN
·
Setting Temperature Set Point
·
Press the Blue box - TANK TEMP. SETPOINT
·
A numeric screen will display
·
Input the desired set point by pressing the appropriate numbers.
·
Press ← to enter the selected set point into memory. The maximum
temperature that can be set is 165°F.
6
Advertisement
Table of Contents
