Table of Contents
Advertisement
WARNINGS
Failure to read these warnings may cause the unit to fail.
Failure to read these warnings may cause personal injury or property damage.
·
Equipment should only be operated on a three phase, 208 - 240VAC, 30 Amp
grounded electrical system.
·
Facility engineering will be required to hard wire the equipment electrical
wiring to the proper power source.
·
Never operate the unit (heat, ultrasound or pump) without the appropriate liquid level
in the tank.
·
Never energize the machine power until the unit has been filled with the appropriate
level of water.
·
Keep all hands, fingers and other body parts away from the lip of the lip near
any of the noted lid pinch points to avoid accidental personal injury.
·
Never use flammable liquids or solvents in the unit.
·
Maintain a minimum liquid level in the main tank to the height of the weir.
·
Maintain at least a 2/3 volume of water in the weir for proper operation of the pump.
·
Minimum water level in the tank must be to the height of the low liquid level sensor
for the SONICS, HEAT or PUMP circuits to be operational.
·
Keep lid closed to maximize heating insulation efficiency.
·
Due to the heated liquid in the tank, use racks, baskets, tongs or wires to insert or
remove parts from the tank.
·
Do not operate the unit with wet hands.
·
Use only biodegradable cleaning agents. Never use solvents or flammable cleaning
solvents.
·
Do not rest parts to be cleaned directly on the immersible transducer pack. Severe
transducer erosion will occur.
·
Do not open the internal circuitry of the equipment, disassemble any part or parts, or
move or remove any components or electrical devises.
·
Never attempt to perform maintenance on the equipment when the unit is energized.
·
Never attempt to perform maintenance on the unit when the cleaning solution is hot.
·
Disconnect the power source when moving the unit to a new location.
·
Avoid splashing water outside the tank.
4
Advertisement
Table of Contents
