Table of Contents
Advertisement
OPERATING HINTS
·
Starting with hot water will allow the unit to reach optimum operating temperature
quicker.
·
Do not use de-ionized water if possible in the unit. DI water will accelerate cavitation
erosion in the tank.
·
Never place items to be cleaned directly on the immersible transducers items to be
cleaned should be suspended at least ½" above the tank bottom or on the supplied
tank platform rack.
·
Never allow the unit to operate without liquid. This will cause the unit to fail.
·
Keep the cover closed to heat the liquid faster.
·
After frequent use, the tank should be emptied, rinsed out and wiped with a non-
abrasive cloth.
·
If the lid chatters or squeaks during the lifting or lowering cycle, apply a light,
penetrating oil (WD-40) to the hinges of the lid itself.
EQUIPMENT MAINTENANCE
·
Turn equipment off.
·
Wait at least twenty (20) minutes after the heat circuit is turned off before emptying
the tank.
·
Drain the contaminated cleaning solution from the tank.
·
Rinse the inside of the tank with clean water.
·
Buff the inside of the tank with a clean, soft cloth. Do not use steel wool cleaning
pads as they are too abrasive and will scratch the tank surface.
·
Rinse the tank again.
·
Wipe the inside and the outside of the tank dry with a dry, clean, soft cloth.
·
The lid should remain closed when the equipment is not in use.
·
This tank cleaning procedure should be performed every time the bath is changed.
Thoroughly inspect drain areas for leaks.
·
Keep the bath free of oils, grease and any foreign materials.
·
Skim off oil and grease residue periodically if necessary.
·
Cleaning agents should be changed periodically depending on usage.
·
When discharging bath and waste, follow all environmental and regulatory
requirements. A reputable and licensed waste transportation firm should perform
removal of all waste materials.
·
Omegasonics is not liable for improper handling of waste materials.
13
Advertisement
Table of Contents
