Intelligent Memory Circuit; Charging; Power Bank Function - Fenix E-CP User Manual

Intelligent Memory Circuit
The light memorizes the last selected output excluding Strobe mode. When turned on again the
previously used mode will be recalled.
* The High mode will be activated when turned on again if the light is turned off on Turbo mode.
Charging
1. Open the anti‐dust cap, plug the USB Type‐C socket of the charging cable into the light and the
other end of the charging cable into an electrical outlet.
2. When charging, the charging indicators will flash from left to right to display charging status.
The four indicators will be constant‐on after charging is complete.
3. A 5V/2A or higher‐power adapter must be used for charging this light. The normal charging
time is approximately 2 hours from depletion to full charging, with the 18W or higher‐power fast
charging adapter, and the charging time is approximately 3.5 hours with a 5V/2A adapter.
4. Only Eco, Low and Med modes are available when charging, but the charging time will be
prolonged.
5. Be sure to close the anti‐dust cover once charging is completed to maintain the dustproof and
waterproof ability.
Power Bank Function
1. Switch off the light and open the anti‐dust cap, plug the USB A socket of the charging cable
into the USB‐A port of the light, then connect the other end of the charging cable to the charging
port of the digital device to be charged. Or the USB Type‐C port of the light can be used as the
discharging port, in this way, use a proper charging cable with a USB Type‐C port.