ELECTRICAL SYSTEM
CODES
DTC 60050 - EmerRevr
DTC 60210 - EmerRevr
POSSIBLE CAUSE
A. START UP SEQUENCE
B. BELLY SWITCH SEQUENCE
C. CONTROLLER WIRING FAULT
D. FAULTY TILLER CONTROL CARD
COMPONENT OPERATIONAL CHECK
PROCEDURE OR ACTION:
1. Conduct a visual inspection of all connectors/wiring associated with the fault code.
Are any faults detected/observed?
YES: Repair/replace connector or wiring associated with faults found. Refer to the appropriate Electrical
SystemYRM .
NO: Proceed to Step 2.
2. Re-key the vehicle.
Is the code still present?
YES: Proceed to Step 3.
NO: Problem may be intermittent.
3. Using the PC Service Tool, locate input diagnostics and view belly switch input.
Is belly switch operational?
YES: fault may be intermittent. Inspect belly switch for damage.
NO: Proceed to CAUSE A.
CAUSE A - START UP SEQUENCE
PROCEDURE OR ACTION:
1. This fault code will occur if operator commands traction while traction interlock sensor is off or if operator is
operating tiller arm outside of operational range. Reference the Electrical SystemYRM to identify tiller arm
operational range and to verify actual cause of fault.
Was fault due to interlock or tiller arm operation?
YES: Clear fault.
NO: Proceed to CAUSE B.
Check the Service Manual section in Yale Axcess Online for possible updates and check pertinent Bulletins
Confidential/Proprietary - Do Not Copy or Duplicate
Please refer to the end of this procedure for supporting diagrams.
NOTE
Diagnostic Trouble Codes
9030-20-55