Turtle Alarm Enable; Quick Lift Window; Initial Lift Interval; Full Lift Interval - Yale MPB045VG Maintenance Manual

General Maintenance and Diagnostic Data

Turtle Alarm enable

This parameter sets an alarm to indicate when the
truck has transition from turtle mode (TM1) to turtle
mode 2 (TM2). The truck will transition from TM1 to
TM2 when the truck is been driven in TM1 and turtle
button is depressed while tiller arm transition from
operational region A to operational region B. See
Figure 9030-03-3.
A. OPERATIONAL REGION A
B. OPERATIONAL REGION B
C. OPERATIONAL REGION C
Figure 9030-03-3. Operational Regions

Quick Lift Window

This optional parameter defines the minimum amount
of time that the lift button needs to be depressed to
activate Quick Lift.

Initial Lift Interval

This optional parameter sets the period of time for
which the truck will lift upon Quick Lift command. It
shall be enough to lift up the load from the ground so
that load wheels can move freely.

Full Lift Interval

This optional parameter sets the period of time for
which the truck will lift once traction is commanded
while Quick Lift mode.
Check the Service Manual section in Yale Axcess Online for possible updates and check pertinent Bulletins
9030-03-10

Lift Run Time

This parameter sets the maximum allowable time to
have the motor pump running upon lift command.

BDI Warning (Lift Lock) Enable

This parameter enables the truck to lock the lift
function when BDI reaches a given percent

Warning BDI (Lift Lock Out Percent)

This parameter will set the battery discharge
percentage at which the truck will lock the lift function

Battery-BDI Reset Volts

The reset voltage level is checked only once, when
KSI is first turned on. Note that the BDI Reset Percent
parameter also influences the algorithm that
determines whether BDI Percentage is reset to 100%.
Reset Volts Per Cell should always be set higher than
Full Volts Per Cell.

Battery- BDI Full Volts

The full voltage level sets the Keyswitch Voltage that is
considered to be state-of-charge; when a loaded
battery drops below this voltage, it begins to lose
charge. The BDI (battery discharge indicator)
algorithm continuously calculates the battery state-of-
charge whenever KSI is on.

Battery-BDI Empty Volts

The empty voltage level sets the Keyswitch_Voltage
that is considered to 0% state-of-charge when the
truck is been used (loaded conditions). The BDI
(battery discharge indicator) algorithm continuously
calculates the battery state-of-charge whenever KSI is
on.

Battery-BDI Discharge Time

This parameter has two functions:
Sets the minimum time for the BDI to count
•
down from 100% to 0%. If upon verification
battery voltage is below corresponding BDI
percent, BDI percent will decrement by one
percentage point.
Sets the frequency at which the BDI will check
•
the battery voltage. If upon verification battery
voltage is below corresponding BDI percent,
BDI percent will decrement by one percentage
point.
Confidential/Proprietary - Do Not Copy or Duplicate
ELECTRICAL SYSTEM