Mini CONVERTIBLE Owner's Manual page 222

CONTROLS
Therefore, a distance of 4 in/10 cm must
be maintained in every direction when op-
erating the device.
Mounting position of the product.
Safety information
Warning
When charging a device that meets the Qi
standard in the wireless charging tray, any
metal objects located between the device
and the tray can become very hot. Placing
storage devices or electronic cards, such
as chip cards, cards with magnetic strips
or cards for signal transmission, between
the device and the tray may impair the
card function. There is a risk of injury and
risk of damage to property. When charg-
ing mobile devices, make sure there are no
objects between the device and the tray.
NOTICE
The tray is intended for mobile phones up
to a particular size. Forceful inserting of
the mobile phone into the tray can damage
the tray or the mobile phone. There is a
risk of damage to property, among other
potential damage. Observe the maximum
dimensions for mobile phones. Do not
force the mobile phone into the tray.
222
Interior equipment
Online Edition for Part no. 01405A53AA0 - II/22
Functional requirements
– Ignition or standby state is switched on.
– The mobile phone must compatibly sup-
port the required Qi standard. Compati-
ble mobile phones, refer to page 52.
If the mobile phone does not support the
Qi standard, the mobile phone can be
charged using a special Qi-compatible
charging case.
– Use only protective sleeves and covers
up to a maximum thickness of
0.07 in/2 mm. Otherwise, the charging
function may be impaired.
– The mobile phone must not exceed the
maximum size of approximately 5.9 x
3.07 x 0.62 in/150 x 78 x 16 mm.
Overview
The wireless charging tray is located in the
center armrest.
1 Front holder with LED
2 Storage area
3 Movable retaining clip
Inserting the mobile phone
1. Open the center armrest.
2. Push back the retaining clip.